USB2ANY Firmware is continuously reading a device register for the interval of "{{wdInterval}}" for watchdog operation.
Programming EEP_INTADDR to 1
• After programming is done, CLR_REG will be set to 1 to reset the device.• Please remove jumpers J13 (ADDR2), J14(ADDR1), J15(ADDR0) to validate External PWM/CLK after programming is done. • Use EEP_DEVADDR which is the internal address to connect back with the device again.
Please wait !....Programming EEP_INTADDR to 1
DONE
Steps for switching to {{_getActiveMode(isFs0)}} mode
1
Remove jumper connecting GND and FS in J12
2
Populate the jumper to connect FS and Vsup in J12
1
Remove jumper connecting FS and Vsup in J12
2
Populate the jumper to connect GND and FS in J12
DONE
Operating Mode
NormalFail-Safe State 0Fail-Safe State 1
Error Flag
ERR
Clear
Switch to FS0
Switch to FS1
Reset to Normal Mode
Force Fail State
Enter PROG Mode
Enable All
Disable All
PWM Duty-cycle
Output Current
PWM Duty-cycle Setting
[[tooltipText.2]]
Advanced Settings
X
PWM FREQ
Share PWM
Use PWM duty-cycle of Channel 0 for all channels
Enable 8-12 Look-up Table
External PWM/Clock
Use External PWM Source
PWM0
Duty-cycle: %
Freq: Hz
PWM1
Duty-cycle: %
Freq: Hz
PWM0 is functional as external active low PWM for OUT0-5 and the PWM1 is functional as external active low PWM for OUT6-11
Use External Clock
Freq: Hz
Set EEP_INTADDR to 1
EEP_INTADDR has to be set to use external PWM/Clock
The external clock frequency should be 256 times of desired PWM frequency. The external clock source is only used in PWM generation.
LUT Enabled
PWM Duty-cycle Value:
Apply to all channels
Output Current
[[tooltipText.3]]
Advanced Settings
X
Current Range Settings
64
128
258
512
Output Current Value:
Apply to all channels
Enable All
Disable All
LED Color
LED Brightness
LED Color
[[tooltipText.4]]
Advanced Settings
X
PWM FREQ
Share PWM
Use PWM duty-cycle of Channel 0 for all channels
Enable 8-12 Look-up Table
External PWM/Clock
Use External PWM Source
PWM0
Duty-cycle: %
Freq: Hz
PWM1
Duty-cycle: %
Freq: Hz
PWM0 is functional as external active low PWM for OUT0-5 and the PWM1 is functional as external active low PWM for OUT6-11
Use External Clock
Freq: Hz
Set EEP_INTADDR to 1
EEP_INTADDR has to be set to use external PWM/Clock
The external clock frequency should be 256 times of desired PWM frequency. The external clock source is only used in PWM generation.