Z-Stack 6.10.00 User’s Guide

Table of contents

• Introduction to the SimpleLink CC13xx/CC26xx SDK
  • Prerequisites
  • SDK - Download and Installation
  • IDE - Download and Installation
• Introduction
• CC13xx and CC26xx Overview
  • Hardware Architecture
  • Sensor Controller
  • Further information
• TI-RTOS (RTOS Kernel) Overview
  • Threading Modules
  • Kernel Configuration
  • Creating vs. Constructing
  • Thread Synchronization
  • Queues
  • Tasks
  • Clocks
  • Power Management
  • TI-RTOS to TI-RTOS7 Migration
• SimpleLink CC13xx/CC26xx SDK Overview
  • Introduction to the CC13xx and CC26xx
  • Introduction to the SimpleLink CC13xx/CC26xx SDK
  • End Production Development Architecture Choices
• Developing Zigbee Applications
  • Application Overview
  • Green Power Application Overview
  • Z-Stack Overview
  • Flash
  • Memory Map
  • Running the Example Applications
  • Network Configurations
  • Power Configuration
  • Zigbee Network Processor (ZNP) Interface
  • MT Interface
  • Product Certification
• Custom Hardware
  • Designing a Custom Board
  • Creating a Custom Board File
  • Change Device Configuration
  • Configuring Device Parameters for Custom Hardware
  • Configuring the RF Front-End for Custom Hardware
  • Set-up SysConfig When Using a Custom Board
  • Initial Board Bring Up
• Zigbee Over-The-Air Firmware Upgrade
  • Z-Stack OTA Upgrade
  • Over-the-Air Download (OAD)
• Wi-Fi Coexistence
  • Two-wire Coex Interface
  • Coexistence Signaling
  • Configuration Options
• Debugging
  • External Resources
  • Debug Interfaces
  • Breakpoints
  • Watching Variables and Registers
  • Memory Watchpoints
  • TI-RTOS Object Viewer
  • Using the Memory Browser
  • Connect the debugger to a running target
  • Optimizations
  • Loading TI-RTOS in ROM Symbols
  • Deciphering CPU Exceptions
  • Debugging guide for serial interfaces
• Memory overview
  • Flash Vector Table
  • Customer Configuration (CCFG) Table
  • RAM
  • Cache
  • AUX RAM
  • Using the AUX RAM as RAM
  • Using the Cache as RAM
• Packet Sniffer
  • Ubiqua Protocol Analyzer
  • Wireshark
• System Configuration (SysConfig)
  • Get started with SysConfig
  • Configure The Board Files with SysConfig
  • Migrating Board Variant
  • Zigbee Configuration
  • Disable SysConfig
• EnergyTrace User Guide
  • EnergyTrace stand-alone Instructions
  • EnergyTrace++ Instructions
  • Using EnergyTrace with an External Target
  • Troubleshooting
• Migration Guide
  • Updating from previous SDKs
• References
• Terms and Acronyms
  • General Terms and Acronyms
  • TI-RTOS Terms and Acronyms
  • Sensor Controller Terms and Acronyms
  • Over-the-Air Download (OAD) Terms and Acronyms